1·The sleeve bearing must be designed and made with close to tolerance to provide the equipment high reliability.
滑动轴承间隙要按高精度设计、制造，才能保证设备的可靠性。
2·The Series 200 engines were a ball bearing designs whereas the earlier Series 100's were plain sleeve bearing engines.
一系列200引擎一球轴承设计，而较早前的100系列的平原套轴承的引擎。
3·For example, if the force operating on a sleeve bearing becomes too high, it will squeeze out the oil film and cause metal-to-metal contact, overheating and rapid failure of the bearing.
例如：如果止推轴承上的作用力过大的话，会挤出油膜，引起金属和金属之间的相互接触，轴承将过热而迅速失效。
4·Based on worksite practice, the paper introduces Cleaning and Overhaul Technology of the chock, bushing, sleeve which are the key parts in the oil film bearing.
本文以现场实际经验为基础，重点介绍了轴承座、锥套和衬套这三个油膜轴承中关键件的清洗和检修技术。
5·The design and structure of the drawing tool for the engine bearing sleeve inside channel is discussed, the drawing technique introduced and the related points put forward.
论述了发动机轴承衬套油线拉制工具的设计及其结构，介绍了油线拉制的方法，并提出了有关注意事项。
6·Rudder pintle to be forged steel and fitted with stainless steel sleeve and a synthetic bush bearing.
舵栓采用铸造钢并用不锈钢套和一个合成衬套轴承安装。
7·To prevent the reducer output shaft bearing perishable and more frequent replacement of the drawbacks of nylon sleeve.
防止了减速机输出轴支座易坏及更换尼龙套较为频繁的弊端。
8·The die forging process for the small type bearing bushings has been described in this article, as well as the design outline of the assembled sleeve die.
介绍了小型轴承套的胎模锻造工艺，并详述了组合套模的设计要点。
9·Solved with the spindle sleeve and bearing components with the layout of the form of the key technical problems.
解决了套筒与主轴的配合及支承部件的布置形式等关键技术问题。
10·The shaft is fixed to the wheel body and arranged uniformly on the tooth path, and the outside diameter of the bearing or the shaft sleeve jacketed on the shaft is as wide as the tooth path.
所述轴固联于轮体，等分排列于齿道上，套于轴的轴承或轴套的外径与齿道等 宽。